15A NCAC 02T .0504. APPLICATION SUBMITTAL  


Latest version.
  • (a)  The requirements in this Rule apply to all new and expanding facilities, as applicable. 

    (b)  Soils Report.  A soil evaluation of the disposal site shall be provided to the Division by the applicant in a report that includes the following.  If required by G.S. 89F, a soil scientist shall prepare this evaluation:

    [Note:  The North Carolina Board for Licensing of Soil Scientists has determined, via letter dated December 1, 2005, that preparation of soils reports pursuant to this Paragraph constitutes practicing soil science under G.S. 89F.]

    (1)           Field description of soil profile, based on examinations of excavation pits or auger borings, within seven feet of land surface or to bedrock describing the following parameters by individual diagnostic horizons:

    (A)          thickness of the horizon;

    (B)          texture;

    (C)          color and other diagnostic features;

    (D)          structure;

    (E)           internal drainage;

    (F)           depth, thickness, and type of restrictive horizon(s); and

    (G)          presence or absence and depth of evidence of any seasonal high water table (SHWT).

    Applicants shall dig pits when necessary for evaluation of the soils at the site.

    (2)           Recommendations concerning loading rates of liquids, solids, other wastewater constituents and amendments.  Annual hydraulic loading rates shall be based on in-situ measurement of saturated hydraulic conductivity in the most restrictive horizon for each soil mapping unit.  Maximum irrigation precipitation rates shall be provided for each soil mapping unit. 

    (3)           A field-delineated soil map delineating soil mapping units within each land application site and showing all physical features, location of pits and auger borings, legends, scale, and a north arrow.  The legends shall also include dominant soil series name and family or higher taxonomic class for each soil mapping unit.

    (4)           A representative soils analysis (i.e., Standard Soil Fertility Analysis) conducted on each land application site.  The Standard Soil Fertility Analysis shall include the following parameters:

    (A)          acidity,

    (B)          base saturation (by calculation),

    (C)          calcium,

    (D)          cation exchange capacity,

    (E)           copper,

    (F)           exchangeable sodium percentage (by calculation),

    (G)          magnesium,

    (H)          manganese,

    (I)            percent humic matter,

    (J)            pH,

    (K)          phosphorus,

    (L)           potassium,

    (M)         sodium, and

    (N)          zinc.

    (c)  Engineering design documents.  If required by G.S. 89C, a professional engineer shall prepare these documents.  The following documents shall be provided to the Division by the applicant: 

    [Note:  The North Carolina Board of Examiners for Engineers and Surveyors has determined, via letter dated December 1, 2005, that preparation of engineering design documents pursuant to this Paragraph constitutes practicing engineering under G.S. 89C.]

    (1)           engineering plans for the entire system, including treatment, storage, application, and disposal facilities and equipment except those previously permitted unless those previously permitted are directly tied into the new units or are critical to the understanding of the complete process;

    (2)           specifications describing materials to be used, methods of construction, and means for ensuring quality and integrity of the finished product including leakage testing; and

    (3)           engineering calculations including hydraulic and pollutant loading for each treatment unit, treatment unit sizing criteria, hydraulic profile of the treatment system, total dynamic head and system curve analysis for each pump, buoyancy calculations, and irrigation design.

    (d)  Site plans.  If required by G.S. 89C, a professional land surveyor shall provide location information on boundaries and physical features not under the purview of other licensed professions.  Site plans or maps shall be provided to the Division by the applicant depicting the location, orientation and relationship of facility components including: 

    [Note:  The North Carolina Board of Examiners for Engineers and Surveyors has determined, via letter dated December 1, 2005, that locating boundaries and physical features, not under the purview of other licensed professions, on maps pursuant to this Paragraph constitutes practicing surveying under G.S. 89C.]

    (1)           a scaled map of the site, with topographic contour intervals not exceeding 10 feet or 25 percent of total site relief and showing all facility-related structures and fences within the treatment, storage and disposal areas, and soil mapping units shown on all disposal sites;

    (2)           the location of all wells (including usage and construction details if available), streams (ephemeral, intermittent, and perennial), springs, lakes, ponds, and other surface drainage features within 500 feet of all waste treatment, storage, and disposal site(s) and delineation of the review and compliance boundaries;

    (3)           setbacks as required by Rule  .0506 of this Section; and

    (4)           site property boundaries within 500 feet of all waste treatment, storage, and disposal site(s).

    (e)  A hydrogeologic description prepared by a Licensed Geologist, Licensed Soil Scientist, or Professional Engineer if required by Chapters 89E, 89F, or 89C respectively of the subsurface to a depth of 20 feet or bedrock, whichever is less, shall be provided to the Division by the applicant for systems treating industrial waste and any system with a design flow over 25,000 gallons per day.  A greater depth of investigation is required if the respective depth is used in predictive calculations.  This evaluation shall be based on borings for which the numbers, locations, and depths are sufficient to define the components of the hydrogeologic evaluation.  In addition to borings, other techniques may be used to investigate the subsurface conditions at the site.  These techniques may include geophysical well logs, surface geophysical surveys, and tracer studies.  This evaluation shall be presented in a report that includes the following components:

    [Note:  The North Carolina Board for Licensing of Geologists, via letter dated April 6, 2006, North Carolina Board for Licensing of Soil Scientists, via letter dated December 1, 2005, and North Carolina Board of Examiners for Engineers and Surveyors, via letter dated December 1, 2005, have determined that preparation of hydrogeologic description documents pursuant to this Paragraph constitutes practicing geology under G.S. 89E, soil science under G.S. 89F, or engineering under G.S. 89C.]

    (1)           a description of the regional and local geology and hydrogeology;

    (2)           a description, based on field observations of the site, of the site topographic setting, streams, springs and other groundwater discharge features, drainage features, existing and abandoned wells, rock outcrops, and other features that may affect the movement of the contaminant plume and treated wastewater;

    (3)           changes in lithology underlying the site;

    (4)           depth to bedrock and occurrence of any rock outcrops;

    (5)           the hydraulic conductivity and transmissivity of the affected aquifer(s);

    (6)           depth to the seasonal high water table;

    (7)           a discussion of the relationship between the affected aquifers of the site to local and regional geologic and hydrogeologic features;

    (8)           a discussion of the groundwater flow regime of the site prior to operation of the proposed facility and post operation of the proposed facility focusing on the relationship of the system to groundwater receptors, groundwater discharge features, and groundwater flow media; and

    (9)           if the SHWT is within six feet of the surface, a mounding analysis to predict the level of the SHWT after wastewater application.

    (f)  Property Ownership Documentation shall be provided to the Division by the applicant consisting of:

    (1)           legal documentation of ownership (i.e., contract, deed or article of incorporation);

    (2)           written notarized intent to purchase agreement signed by both parties, accompanied by a plat or survey map; or

    (3)           written notarized lease agreement signed by both parties, specifically indicating the intended use of the property, as well as a plat or survey map.  Lease agreements shall adhere to the requirements of 15A NCAC 02L .0107.

    (g)  Public utilities shall submit to the Division a Certificate of Public Conveyance and Necessity or a letter from the NC Utilities Commission stating that a franchise application has been received.

    (h)  A complete chemical analysis of the typical wastewater to be discharged shall be provided to the Division by the applicant for industrial waste, including Total Organic Carbon, 5-day Biochemical Oxygen Demand (BOD5), Chemical Oxygen Demand (COD), Nitrate Nitrogen (NO3-N), Ammonia Nitrogen (NH3-N), Total Kjeldahl Nitrogen (TKN), pH, Chloride, Total Phosphorus, Phenol, Total Volatile Organic Compounds, Fecal Coliform, Calcium, Sodium, Magnesium, Sodium Adsorption Ratio (SAR), Total Trihalomethanes, Toxicity Test Parameters and Total Dissolved Solids.

    (i)  A project evaluation and a receiver site agronomic management plan (if applicable) and recommendations concerning cover crops and their ability to accept the proposed application rates of liquid, solids, minerals and other constituents of the wastewater shall be provided to the Division by the applicant.

    (j)  A residuals management plan as required by Rule .0508 of this Section shall be provided to the Division by the applicant.  A written commitment is not required at the time of application; however, it must be provided to the Division prior to operation of the permitted system.

    (k)  A water balance shall be provided to the Division by the applicant that determines required effluent storage based upon the most limiting factor of the hydraulic loading based on either the most restrictive horizon or groundwater mounding analysis; or nutrient management based on either agronomic rates for the specified cover crop or crop management.

     

History Note:        Authority G.S. 143-215.1; 143-215.3(a);

Eff. September 1, 2006.